Metoda usvajanja: Proglašavanje
Faza izrade: 40.20 - Javna rasprava o nacrtu BAS standarda (nsBAS)
Datum realizacije: 2017-10-27
Predviđeni datum naredne faze: 2017-12-26

Referentni broj izvornog dokumenta i stepen usklađenosti:
EN 10152:2017, identičan

Naslov

Elektrolitički pocinčani hladno valjani čelični pljosnati proizvodi za hladno oblikovanje - Tehnički uvjeti isporuke

Naslov na engleskom jeziku

Electrolytically zinc coated cold rolled steel flat products for cold forming - Technical delivery conditions

Područje primjene

Nema informacija.

Područje primjene na engleskom jeziku

This European Standard specifies requirements for continuously electrolytic zinc coated cold rolled flat products of low carbon steels suitable for cold forming according to Table 1 in rolled widths above or equal to 600 mm and thicknesses from 0,35 mm up to and including 3 mm, delivered as strip (in coil form), sheet, slit strip or cut lengths obtained from slit strip or sheet. NOTE 1 This European Standard can also be applied to continuously electrolytic zinc coated flat products of: a) steels according to EN 10139 (cold rolled strip in rolled widths < 600 mm), b) steels normally characterized by minimum yield strength or minimum tensile strength values in addition to formability parameters, e. g. 1) steels with high yield strength and improved formability according to EN 10268 (cold rolled flat products), 2) multiphase steels (cold rolled or hot rolled) according to prEN 10338, 3) steels for construction according to national or regional standards (see e. g. DIN 1623). NOTE 2 By agreement at the time of enquiry and order this European Standard can be applied to continuously electrolytic zinc coated hot-rolled steel flat products (e.g. according to EN 10025-1 and -2, EN 10111, EN 10149-1 to EN 10149-3, etc.). NOTE 3 As the mass of the zinc coating applied is relatively small, the material is not intended to withstand outside exposure without further chemical treatment and painting.

Tehnički komitet


ICS



Direktiva/Uredba

Nema informacija.

Nacionalne aktivnosti



Radni materijal

Samo članovi tehničkog komiteta imaju pristup radnom materijalu. Ukoliko ste član, molimo prijavite se sa vašim nalogom i dobiće te pristup dokumentima. Moj nalog